Electronics > Projects, Designs, and Technical Stuff
Help needed identifying an RF connector to an old ADVANTEST
(1/2) > >>
gissiken:
I have an old ADVANTEST R3272 Spectrum Analyzer 9KHZ to 26.5GHZ that I am attempting to rescue.

The connector in the front is something I cannot recognize. 
Can anyone tell me what this is?

coppercone2:
are you sure thats a real connector not a slot machined out for some reason (in house test)?

normally APC-7 right? i am not sure but I think the side cuts look kinda shitty for 27.5 GHz.
KaneTW:
Doesn't look like any connector I recognize. https://www.advantest.com/documents/11348/146687/pdf_mn_ER3272_OPERATING_MANUAL.pdf specifies a N-type, so this is likely a custom mod.
Twoflower:
Looking around that type of connector appears several time. So that's not a custom mod. But no clue here either.
gissiken:
Thanks for Reply! I don't know anything about this connector. Have order an APC-7 but I don’t know. Waiting also on a Planar Crown connector. Started to look into changing the whole connector to N-Type. Recognize the back end of the connector?

PS! found later on that it was 3,5 mm air dialectic, for those who are wondering. good for 33 GHz.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod