Electronics > Projects, Designs, and Technical Stuff

Help Simulating Application Circuit #5 of LTC3350 Datasheet using LTspice

(1/1)

joe306:
Hello, I am trying to simulate a circuit found on page 41 of the datasheet for the LTC3350. I am using LTSpice and when I run the Simulation get the message "Pseudo-Transcient Analysis that runs forever until I hit the ESC button. That's my first problem the second is that I'm not getting the correct Vout voltage. I have all my parameters set like the datasheet.

I'll upload the datasheet and LTSpice design.

Thank you,
Joe

Jay_Diddy_B:
Hi.

Check these two boxes:



And it will add startup and uic to the simulation command.

Everything will work nicely.

Also:



Regards,

Jay_Diddy_B

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod