Electronics > Projects, Designs, and Technical Stuff

Help with identifying a connector

(1/1)

V3rzeT:
Hi, I have been searching for a while for a "molex" 4-pin 90 degrees DIP connector, I couldn't find any on LCSC (the website where I buy most of my components) and couldn't find any on Mouser either.

This is the connector I am looking for:



If anyone knows any compatible connector that I can get on LCSC (or if not, then Mouser), please let me know!

bob91343:
Looks like the standard floppy disc power connector.

WattsThat:
Yep, dead standard mate-n-loc

https://www.mouser.com/ProductDetail/TE-Connectivity-AMP/1-480424-0?qs=ko0lFLRalIOE%2FKdC2RXHBg%3D%3D&gclid=Cj0KCQjwhb36BRCfARIsAKcXh6FpUjprvv7SQs0bFouNSNdxzjvyt2JGmPAIGv3UTfweWHnWkhixROMaAmBVEALw_wcB

V3rzeT:
Thanks, after looking through TE's website, it seems like I found exactly what I need, 770846-1 it's the same connector that you sent but just 90 degrees and wire to board.

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod