Electronics > Projects, Designs, and Technical Stuff
HF Conducted emissions - Spectrum analyzer
(1/1)
mattko:
Hello,

I'm doing pre compliance for conducted emissions and the measurements at high frequencies (80 MHz - 108 MHz) are lower, comparing to measurements done at a certified laboratory. From your experience, which things affect measurements at these frequencies?

I tried the spectrum analyzer at the certified laboratory and it performed the same as their SA, so the problem should be in our test setup.

I'm using a 12 V battery, 5uH LISN, short cables from LISN to DUT, GND plane under DUT (same distance to DUT), R&S SA

Any ideas would be welcome!
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod