EEVblog Electronics Community Forum
A Free & Open Forum For Electronics Enthusiasts & Professionals
Welcome,
Guest
. Please
login
or
register
.
Did you miss your
activation email
?
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
This topic
This board
Entire forum
Google
Bing
Home
Help
Search
About us
Links
Login
Register
EEVblog Electronics Community Forum
»
Electronics
»
Projects, Designs, and Technical Stuff
»
High Voltage Generator Mosfet drive flyback transformer
« previous
next »
Print
Search
Pages: [
1
]
Go Down
Author
Topic: High Voltage Generator Mosfet drive flyback transformer (Read 359 times)
0 Members and 1 Guest are viewing this topic.
mu34tant
Newbie
Posts: 1
Country:
High Voltage Generator Mosfet drive flyback transformer
«
on:
June 29, 2022, 11:14:48 pm »
I want to use this driver board (
https://www.ebay.com/itm/384300834133
) with this transformer (
https://www.ebay.com/itm/402679163644
). The driver board is designed for 12v. The transformer is primary is setup for 125v. The driver board uses UC3845b timing chip and can be powered offline. I will have a 125v source (
https://www.ti.com/lit/ds/slvs036n/slvs036n.pdf
) figure 13. I am going to use this mosfet that has characteristics of the 110n8f6 except a much higher Vds (
https://www.mouser.com/datasheet/2/196/Infineon-IPP051N15N5-DS-v02_01-EN-994624.pdf
) 051n15n5. There will be a common ground for the 12v and 125v supply. There is a 1ohm 5w resistor between 12v supply and mosfet source. I was thinking of going with a 0.1ohm 5w resistor between 125v source and 051n15n5 source. Is this a good idea?
«
Last Edit: June 29, 2022, 11:16:43 pm by mu34tant
»
Logged
Print
Search
Pages: [
1
]
Go Up
« previous
next »
Share me
Smf
EEVblog Electronics Community Forum
»
Electronics
»
Projects, Designs, and Technical Stuff
»
High Voltage Generator Mosfet drive flyback transformer
There was an error while thanking
Thanking...
EEVblog Main Site
EEVblog on Youtube
EEVblog on Twitter
EEVblog on Facebook
EEVblog on Odysee