| Electronics > Projects, Designs, and Technical Stuff |
| Homemade IGBT MIG welder with ATX PSU parts. [blown yet again][blown count: 5] |
| << < (25/32) > >> |
| strawberry:
isnt that your voltage is too high for MIG welder. arc voltage should be 30V max |
| Refrigerator:
--- Quote from: strawberry on July 24, 2019, 07:16:37 pm ---isnt that your voltage is too high for MIG welder. arc voltage should be 30V max --- End quote --- It's an inverter welder, the diodes see high voltage (not mains of course) impulses, which then get smoothed out by the inductor, very similar to a buck converter. The 4V i got were at whatever the max duty cycle (because it was undervoltage) i set the welder to was (85% i think), assuming 1:3 ratio between primary and secondary voltage i would get 113V when running on mains at that max set duty cycle. If 113V = 85% then to get 21V (common MIG voltage) the controller would reduce the duty cycle to roughly 16%. Also since during the test on 12V the welder was basically unloaded (except for the 100Ω idle load resistor) i can assume that 4V was also my peak voltage and therefore i can also assume that 113V would be the peak voltage on mains. |
| Refrigerator:
--- Quote from: xavier60 on July 24, 2019, 06:53:38 pm ---A schematic would make it possible to follow what is being done. --- End quote --- I planned to release the schematic in my blog as soon as i finished the welder because i kept changing the design and component values constantly. But i do have a crude one drawn (as a guide when soldering), although i doubt that it would be very useful. Ps: please excuse the crudity of the schematic, last time i used KiCAD was years ago. |
| strawberry:
should be ~45V for scratch start stick welder 113V is fine |
| Refrigerator:
--- Quote from: strawberry on July 24, 2019, 09:36:44 pm ---should be ~45V for scratch start stick welder 113V is fine --- End quote --- Google says 12 to 30V for MIG |
| Navigation |
| Message Index |
| Next page |
| Previous page |