Electronics > Projects, Designs, and Technical Stuff
How to convert an adapter which is using usb to bluetooth?
(1/3) > >>
Chriss:
Hi!
I'm curious doe this schematic is possible to convert in a way to use it with bluetooth instead of usb?
http://emmd.ro/wp-content/gallery/vag-com-usb/schematic.jpg

Is it possible to use something like the HC-05 or HC-06 BT module?

I'm thinking to take out the ftdi ic and the rx/tx line to hook up to the BT module, but I see there is the DCD and TRS line too and on the BT module I can't see any of them.

BTW. I already found another module where only the Rx & Tx pins are connected to the FT232 ic.
If I would interchange the FT232 with a BT module would that maybe work?
Maybe to take care about the voltage level on the Rx & Tx line on the FT232 to make it compatible with the HC-05 or HC-06 module.

What do you think, how could such of interface be converted from USB to BT?

Thanks for any suggestion or idea.
mvs:
K/L interface has custom baudrate of 10400 baud, so you will need to set up UART speed of BT module accordingly. Firmware of chinease modules like HC05 is very limited, i doubt that you can do it via AT commands. Perhaps you could set it via CSR Programmer and PSTool directly.
 

Chriss:
Thank you very much for this good suggestion.
I'm not limited to that china bt module.
Can you pls advice a good bt module what I coul use for such of experiment?
Thanks.
mvs:
Bluegiga (now Silabs) modules with iWRAP firmware like WT12-A-AI and Roving Networks RN41/42 (now Microchip) are quite good. Hardware in this modules is essentialy the same as in HC05, CSR BC04 Ext chipset.
rvalente:
Those simple and cheap elm327 bluetooth adapters are not suitable for you?
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod