Electronics > Projects, Designs, and Technical Stuff

How to design ripple meter for 19V lines?

(1/2) > >>

I had this idea for a long time.

What I want to do:

Measure ripple/noise level on AC adapters for laptops.

So instead of using a scope evey time + resistors for dummy load I was thinking to build a meter that will test these and provide Voltage, Current and Ripple measurements.

Most of the AC adapters for laptops are 18.5 - 19.5V and currents 3.42 - 7.5A. Operating frequency is from 10Khz to 50Khz from what I measured. Whats happening with these is that filtering capacitors on 19V line goes bad or change value and this causing different kind of problems for laptops. Sometimes it does not charge all the time, it turns off randomly etc.
I have also seen main filtering capacitor goes bad.

We all know that weak capacitor will recover when temperature goes up, so this mean if AC adapter is not used it may not work OK untill it warms up etc..

Im not designer but we should be able to detect 120Hz modulated ripples in case that main capacitor is not good and frequencies from 10Khz to 50Khz. All these should be measured with a small analog meter, under maximum dummy load, in pp.

That Daves dummy load meter could be used for dummy load and we just need ripple meter.

Does anybody have schematic for ripple meter or some tips how to make it so that it measure those frequencies?

How about a high-pass filter (capacitor) to block DC and a DMM on AC with enough bandwidth? Or a DIY AC meter (I don't think true RMS is a big deal for this, you're mainly looking for order of magnitude, so averaging is fine) if you want a stand-alone instrument.

You would need some kind of load (ripple tends to increase with load), which can either be a laptop running some kind of stress test+charging battery or a dummy load.

I was thinking to use variable dummy load with MOSFET and separate ampmeter, this way if AC adapter is rated at 4A maximum I can set that current and measure ripple :)

DC-blocking capacitor and a precision rectifier op-amp circuit should be all that is needed. Scale the feedback gain resistor as needed.

Are you looking at the peak voltage or RMS?

Yes you need a DC blocking capacitor, precision rectifier and a peak detector.


[0] Message Index

[#] Next page

There was an error while thanking
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod