Electronics > Projects, Designs, and Technical Stuff

How to find an expert STM32 contract developer

(1/2) > >>

Pauldg123:
Hi all,

have tried posting on various freelancing sites previously, with mixed results, so my question is: how would you find a quality STM32 expert freelancer for firmware development?

The project will likely take 40-80 hours, paying commercial rates.

Regards,
Paul

Yansi:
You want expert for what? There is a huge diversity between STM32 micros. It is very hard to find a contractor if you can't specify relevant info.

Is it a SW or HW development? What HW is involved? Multimedia application with graphics, cameras, audio, wireless? Lora? Wifi? BLE? Battery powered? Application with USB, ETH,..?

Even though I have worked with STM32 for years, even in ST directly, I would NOT consider myself an expert on all of above. If you are looking for a contractor, you need to specify more info, other than "STM32".

PS: It is up to the contractor to estimate the time it'll take, not you.

voltsandjolts:

--- Quote from: Pauldg123 on August 30, 2020, 08:53:51 am ---how would you find a quality STM32 expert freelancer for firmware development?

--- End quote ---

Posting in this forum is a good start.
In fact, I wouldn't know where else to look  8)

Bucephalus:
Hi Paul

I'm new here and have no experience with STM32 development. However my only advice to you would be to, yes make sure you can find someone you think is capabable, but also you have to be able to sense that you can get along with them too. Remember you're taking the risk by spending hard-earned money on trying to create a commercial success so if you can sense someone is hungry, has the knowledge and is humble you are on a winner.

Cheers
David.

AndyC_772:
Hi

I might be able to help. Can you provide some more details about your project please?

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod