Electronics > Projects, Designs, and Technical Stuff

I need help in using the schematic diagram

(1/2) > >>

K-Experiment:
I need help
there is an amplifier kit schematic diagram but i dont know how to connect the audio directly to the board(the switches were not included apparently)
the audio input connection is unknown.

StillTrying:
The audio signal input looks like it's the "1" under "VOLUME".
Audio ground doesn't seem to be shown, it's probably the "3" under "VOLUME".

PA0PBZ:

--- Quote from: StillTrying on April 11, 2019, 12:04:35 pm ---The audio signal input looks like it's the "1" under "VOLUME".
Audio ground doesn't seem to be shown, it's probably the "3" under "VOLUME".

--- End quote ---

I'd say it's missing from the diagram. At first I had the same thought, the audio goes to the leftmost MON switch but from there it only goes to the LINE OUT.
And don't forget it is pretending to be stereo...

StillTrying:
"At first I had the same thought, the audio goes to the leftmost MON switch but from there it only goes to the LINE OUT. And don't forget it is pretending to be stereo..."

And me. The 4 rightmost switches seem to have small hard to see connections to the MON's "looped around" connection.

james_s:
It sure would be nice if they'd provide a proper schematic, I hate these drawings that show wires connecting to pins on drawings of actual components, it's very difficult to follow where anything goes, especially if you don't have exactly the same components.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod