Electronics > Projects, Designs, and Technical Stuff

Is this a new method?

<< < (7/7)

CHAMPIGNON:

--- Quote from: tooki on January 17, 2025, 07:06:45 pm ---. To judge the quality we’d need some nice, sharp photos or scans of the etched board.


--- End quote ---
Are the following pictures sufficient?
where track width =0.5MM and  clearance =0.5mm

phansel:

--- Quote from: tooki on January 15, 2025, 07:41:13 pm ---Actually, I think very few people here are involved in mid-to-large-scale manufacturing. I can’t be absolutely sure, since there aren’t any statistics, but I very much get the impression that people with mid-to-large-scale manufacturing expertise are decidedly rare here. And to be very blunt, that isn’t surprising, since this isn’t a Chinese-language forum, and China is where the lion’s share of large-scale manufacturing is done.

--- End quote ---

I'm sure on the whole you're correct, but "very few" is not zero. Try not to be so discouraging!

CHAMPIGNON:

--- Quote from: phansel on January 18, 2025, 02:57:51 am ---
--- Quote from: tooki on January 15, 2025, 07:41:13 pm ---Actually, I think very few people here are involved in mid-to-large-scale manufacturing. I can’t be absolutely sure, since there aren’t any statistics, but I very much get the impression that people with mid-to-large-scale manufacturing expertise are decidedly rare here. And to be very blunt, that isn’t surprising, since this isn’t a Chinese-language forum, and China is where the lion’s share of large-scale manufacturing is done.

--- End quote ---

I'm sure on the whole you're correct, but "very few" is not zero. Try not to be so discouraging!

--- End quote ---
Yes, many people dislike it when others complete their work, as it makes them feel prouder when they succeed.

tooki:

--- Quote from: phansel on January 18, 2025, 02:57:51 am ---
--- Quote from: tooki on January 15, 2025, 07:41:13 pm ---Actually, I think very few people here are involved in mid-to-large-scale manufacturing. I can’t be absolutely sure, since there aren’t any statistics, but I very much get the impression that people with mid-to-large-scale manufacturing expertise are decidedly rare here. And to be very blunt, that isn’t surprising, since this isn’t a Chinese-language forum, and China is where the lion’s share of large-scale manufacturing is done.

--- End quote ---

I'm sure on the whole you're correct, but "very few" is not zero. Try not to be so discouraging!

--- End quote ---
It was neither discouraging nor encouraging, I was simply correcting a statement I believe to be factually untrue. None of that changes any of the evaluation of the method proposed here.

Navigation

[0] Message Index

[*] Previous page