Electronics > Projects, Designs, and Technical Stuff
JLM Electronic Load, 0-30V, 0-4A, 1mV/1mA resolution
<< < (4/5) > >>
trinhvanthien:

--- Quote from: JeanLeMotan on May 31, 2019, 07:33:00 pm ---..... and Reset to VCC for the screen to work.


--- End quote ---
Great! it worked
JeanLeMotan:

--- Quote from: trinhvanthien on June 01, 2019, 01:47:12 am ---
--- Quote from: JeanLeMotan on May 31, 2019, 07:33:00 pm ---..... and Reset to VCC for the screen to work.


--- End quote ---
Great! it worked

--- End quote ---

Great!
What will you be using for the case? If you have a 3d printer you could try the one that I use, it's uploaded on github.
trinhvanthien:

--- Quote from: JeanLeMotan on June 01, 2019, 10:22:52 am ---
Great!
What will you be using for the case? If you have a 3d printer you could try the one that I use, it's uploaded on github.

--- End quote ---
thank you for the suggestions....I will try.
Rerouter:
Possible suggestion. If you divide the load voltage into the dac vref pin. You end up with a constant resistance mode with a few 10s of KHz bandwidth
trinhvanthien:
To @JeanLeMotan
I have 2 problems:
1 - Fan does not run when temperature reaches 70 degrees
2 - The value is not saved to the memory card...
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod