Electronics > Projects, Designs, and Technical Stuff

JLM Electronic Load, 0-30V, 0-4A, 1mV/1mA resolution

<< < (4/5) > >>

trinhvanthien:

--- Quote from: JeanLeMotan on May 31, 2019, 07:33:00 pm ---..... and Reset to VCC for the screen to work.


--- End quote ---
Great! it worked

JeanLeMotan:

--- Quote from: trinhvanthien on June 01, 2019, 01:47:12 am ---
--- Quote from: JeanLeMotan on May 31, 2019, 07:33:00 pm ---..... and Reset to VCC for the screen to work.


--- End quote ---
Great! it worked

--- End quote ---

Great!
What will you be using for the case? If you have a 3d printer you could try the one that I use, it's uploaded on github.

trinhvanthien:

--- Quote from: JeanLeMotan on June 01, 2019, 10:22:52 am ---
Great!
What will you be using for the case? If you have a 3d printer you could try the one that I use, it's uploaded on github.

--- End quote ---
thank you for the suggestions....I will try.

Rerouter:
Possible suggestion. If you divide the load voltage into the dac vref pin. You end up with a constant resistance mode with a few 10s of KHz bandwidth

trinhvanthien:
To @JeanLeMotan
I have 2 problems:
1 - Fan does not run when temperature reaches 70 degrees
2 - The value is not saved to the memory card...

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod