Electronics > Projects, Designs, and Technical Stuff
Laboratory Amplifier
<< < (5/5)
MaxFrister:
The board is in the mail -- or at least on a slow boat.  It is hard to complain about 10 boards for $11 delivered.



I made a few more tweaks to the layout and added more resistors to allow for calibration.   I'll post an update in a few weeks or months after testing.

I may very well leave RV101 off the board if it does not seem necessary or helpful.
MaxFrister:
I finally got around to putting this in a chassis.  For power I was able to recycle a defective torroidial transfromer from my Datron 1081. 

The amp performs mostly as expected.  There were some issues with pcb footprints.  The LF411 is too slow so I did not reach my design bandwidth of 100Khz at +46dB.  The front end is wrong; my attempt to make it symmetric around ground is incorrect.  Right now, neither AC coupling nor oscilloscope probe compensation work as intended.

I probably should add some labels to the controls.


Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod