Electronics > Projects, Designs, and Technical Stuff
Largest Milled PCB yet?
(1/8) > >>
JanTheVan:
Well it feels like it could be, given the amount of time it has taken me!

My ears are ringing, but the result, I think, has come out pretty well! Its not been without pain though, oh no! Wrong feed rates, bad quality cutters, snapping milling bits and the one that almost pushed me over the edge, and scrapped the 2nd attempt, WINDOW AUTOMATIC UPDATE! Yep, 3 hours in to the job, all looking good, windows decided to do an update and shut the PC down! That took a large glass of wine to get over.

All in all it took about 10 hours to mill and drill, about 3 days to get the process sorted from start to finish, so pretty good, the size of the board is 8" X 12" and its double sided. I'll follow up here with a detailed how-to for people that want to give it a go themselves, until then, I've attached a few pictures of my board. Enjoy!

Scott
xyrtek:
Whatever it is you are doing you are doing it right, those look great, well done!!!
Bud:
Awsome, worth framing and hanging on the wall !  :D
soldar:
Two words: spec tacular!
coppercone2:
wow that is slow. if i had to do that i would work on my etch tank again.

it kind of sounds not worth it given the noise.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod