Electronics > Projects, Designs, and Technical Stuff
Li-ion,Li-Poly overcurrent protection PTC Fuse usage consideration
(1/1)
Danesh_SA:
Hi all,
I want to use 1206 1.0A PTC fuse in my design to protect both battery and circuit from short circuit.the device is portable and i use linear Li-ion battery charger (MCP73831) ,i just one to series PTC fuse with battery .
the question is:
-is it a good option for protection?
-where should i place PTC fuse in my design?(just after battery conector on my PCB?)
-a PTC fuse works for my protection condition or one time fuse or fusible resistor?

Thanks!
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod