Electronics > Projects, Designs, and Technical Stuff
Logic level from comparator to raspi gpio
(1/1)
PhelarNord:
Hi!
Im doing a simple voltage monitor with a lm393. I´m going to use a raspbarry pi´s gpio´s to register the state of the comparator outputs but need some advice to translate the output from the comparator to
3.3v. Can i manage this with just a voltage divider or do i have to use something more solid.
Cheers
Ian.M:
The LM393 has an open collector output. Simply use a 10K pullup resistor from its output to Pi +3.3V, and it will be logic level compatible.
N.B. LM393 Gnd must connect to Pi Gnd. You can power its Vcc pin from Pi +5V.
PhelarNord:
Thanks!
I´ll do this in the design :-+
Navigation
[0] Message Index
Go to full version