Electronics > Projects, Designs, and Technical Stuff
Looking for (Optically) isolated data transmission at 500+MBits over ~60cm
<< < (2/2)
Ysjoelfir:
That would be possible in theory, but the problems are:
- Size!
- We would need to re-engineer the whole communication system
- we would need several cards, as the device can have several channels, each needing its own (two) communication interfaces
- I guess that would be pretty expensive as well.
capt bullshot:
Did you read this paper:
https://www.cleverscope.com/files/The%20Cleverscope%20CS448%20Development%20Journey.pdf
?
Ysjoelfir:
I have not but I will read it now as it looks very promissing :)
Marco:

--- Quote from: capt bullshot on August 23, 2019, 11:38:09 am ---Did you read this paper:
https://www.cleverscope.com/files/The%20Cleverscope%20CS448%20Development%20Journey.pdf
?

--- End quote ---

Those Murata FOT's look nice, but they seem to have been memory holed. A couple news releases is all that's on the web. Too good to be allowed to be sold for appropriate prices to plebians? When you look at normal 10+ gbps stuff they want to absolutely rape your wallet, I don't think cleverscope paid those kinds of prices.
jhpadjustable:
If they don't like inductive isolation, how about capacitive? There are digital isolator ICs such as the Si86xx series, with up to 6 channels across up to 5kV in a wide SOIC-16, but they're too slow unless you have a bit of room on the board to (de)mux the data stream over multiple lanes.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod