Electronics > Projects, Designs, and Technical Stuff
Looking for best way of communication between power converters.
Miyuki:
For reasonable impedance at 100s kHz is choke miniature just few uH is enough it is not an expensive solution even for higher currents
MagicSmoker:
--- Quote from: Miyuki on September 11, 2019, 11:42:26 am ---For reasonable impedance at 100s kHz is choke miniature just few uH is enough it is not an expensive solution even for higher currents
--- End quote ---
Injecting a signal at 100's of kHz onto your DC bus? I guess you aren't planning on passing any EMC tests, eh?
Miyuki:
--- Quote from: MagicSmoker on September 11, 2019, 12:05:42 pm ---Injecting a signal at 100's of kHz onto your DC bus? I guess you aren't planning on passing any EMC tests, eh?
--- End quote ---
I dont need to pass proper EMC test
But I dont want something silly, just if impedance at 132kHz will be too low, then just double the frequency to get little more room
And direct emission from two wire cable shouldn't bee so big deal
Navigation
[0] Message Index
[*] Previous page
Go to full version