Electronics > Projects, Designs, and Technical Stuff
looking for some empty enclosure with tweezers
(1/3) > >>
kripton2035:
Hi everyone,
I'm looking for some empty enclosure box to put some electronics inside, a box with tweezers at the end.
something like an mastech ms8910 or ms8911 with no electronic inside, so that I can fill it.
I've tried some site like ali or banggood or ebay without success
does anyone have a link to something like that ?
thanks in advance.
viperidae:
You could attach some SMD probes to a small box. They're pretty cheap on AliExpress
https://www.google.com/search?q=smd+probes&oq=smd+probes&aqs=chrome..69i57.2971j0j7&client=ms-android-motorola-rev2&sourceid=chrome-mobile&ie=UTF-8#imgrc=koOdsArzdU9xjM:
kripton2035:
thanks, I already have these smd probes, different models.
but I'm really looking for something in one box only, with tweezers attached.
if someone has a 3d printable case that would also be fine (I could also define my own but I'm not confident with 3d softwares actually)
I have one mastech 8911 and I really like the way it feels in the hands.
tautech:

--- Quote from: kripton2035 on January 14, 2020, 07:10:14 am ---I have one mastech 8911 and I really like the way it feels in the hands.

--- End quote ---
Have you tried the professional SMD tweezers like these:
https://www.smarttweezers.org/
I've got a pair of ST3 that I've had for years and would replace them in an instant. They look identical to the pictured ST2.
Their later offerings ST5* and LCR** are something else again.

I've heard good stuff about LCR brand tweezers here on the forum too:
https://www.lcrresearch.com/pro1/


Some years back I tried a Mastech set like yours but it didn't match up against the accuracy or form factor of my ST3 so I gave it to a friend.
I use my SMD tweezers heaps and convinced a few other members here to splash out and get something decent and AFAIK none gave regretted doing so.

beanflying:
Something like this https://www.aliexpress.com/item/1905436189.html?spm=2114.12010612.8148356.61.42b64a8dBhOg9O If this is to big the same company has hundreds to pick from, this one is sensibly large for homebrew and tapered to fit in the hand better.

Two bits of FRP Fiberglass strip as tweezers set in a small block inside the case and run the wires (four wire) to the gold plated hardened copper tips. You could even make the tips as a PCB with traces to holes and get them plated by the usual suspects.

Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod