Electronics > Projects, Designs, and Technical Stuff
Low EMI SMPS - How to design to pass FCC
<< < (3/3)
MagicSmoker:

--- Quote from: T3sl4co1l on December 08, 2019, 01:32:12 pm ---...the error amp output saturates above the fault threshold.  So instead of a nice well-behaved current limit, it just fucking shuts down and sits there wheezily burping...
--- End quote ---

Oh, that's an even worse cause for instability than I suspected. Welp, it's still on my Do Not Ever Use Again list.



--- Quote from: MagicSmoker on December 08, 2019, 12:52:43 pm ---Ah, I suppose that figures.  Who cares about theory when it Just Works?  It's just a piddly little power converter, not like it's an airframe with full state vector controls, who cares about analysis... ::) 
--- End quote ---

Somebody clearly doesn't work for Boeing...  :P
T3sl4co1l:
Ouch  >:D
SiliconWizard:

--- Quote from: T3sl4co1l on December 08, 2019, 01:32:12 pm ---Ah, I suppose that figures.  Who cares about theory when it Just Works?

--- End quote ---

A variation of this can be: who cares about theory when it just passes FCC?  ;D
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod