Electronics > Projects, Designs, and Technical Stuff
Low-leakage triac or solid-state relay
<< < (5/5)
Zero999:

--- Quote from: perieanuo on December 14, 2018, 04:32:49 pm ---
--- Quote from: Hero999 on December 14, 2018, 01:44:21 pm ---
--- Quote from: CodyDowling on December 13, 2018, 03:15:20 am ---
--- Quote from: perieanuo on December 09, 2018, 12:39:03 pm ---Hi,
Do you mentioned frequency involved?
Regards,pierre
...


--- End quote ---

I didn't but, ideally, I'd like to be able to get very high impedance up to 100kHz. The RF components seem like they shouldn't start really leaking until much higher, so I thought that might be a good jumping off point.

--- End quote ---
I'm confused.

Do you want to switch 100kHz current with this relay? Or do you just need it to not leak a 100kHz applied between the control and load circuits?

A TRIAC is no good for switching a 100kHz current and MOSFETs will leak a considerable amount, at that frequency. You need a reed relay to switch that frequency current.

--- End quote ---
As I already excluded reed in my earlier post (I understood the signal needed to be switched at high freq,reed can't do quick, not that the signal itself has 100k).
I give up...
In fact hero999 is right if signal is HF and commutation speed is slow, very slow.
I need a coffee :) and clearer specs, which f for signal,which bandwidth for signal to be commuted...


Envoyé de mon iPad en utilisant Tapatalk

--- End quote ---
Yes, I did notice that, but it confused me.

Where did he say he wanted to switch the signal at 100kHz? It seems more like he wanted to switch a 100kHz signal, at a low frequency.

To chop a DC or AC signal up at 100kHz, with isolation, use a couple of MOSFETs driven by a pulse transformer.

You're right. We need a better specification.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod