| Electronics > Projects, Designs, and Technical Stuff |
| matte tin pin contact with ENIG PCB |
| (1/1) |
| Alex Eisenhut:
Good day! Samtec OPP connector http://suddendocs.samtec.com/catalog_english/opp.pdf As you can see these are spring-formed matte-tin-plated pins that mate to a pad on another PCB. They say it should mate to a tin-plated pad. Page 3: http://suddendocs.samtec.com/prints/opp-xx-01-x-s-x-xx-footprint.pdf So what happens if the pad is ENIG instead? Will the Sun go red giant? Will Jupiter turn into a quasar? Will there be some kind of tin-gold intermetallic shenanigans ?? Samtec says this is "not recommended" and won't tell me more than that. Unfortunately the mating board is already done, it's ENIG. |
| wraper:
Likely you will start having contact failures after few months to years. --- Quote ---Unfortunately the mating board is already done, it's ENIG. --- End quote --- Then tin the pads and thoroughly clean from flux. Although I don't advise using connectors of such style (springy) in non gold plated variants. If you want to go with tin, use connectors which strongly bite into solder on the pad. Such as commonly used in HDDs. |
| Alex Eisenhut:
Yeah this connector wasn't my choice, I did leave paste on the mating pads and when the boards got assembled I got an earful when my boss saw the solder. I guess it's a wait and see thing now... :-// |
| Navigation |
| Message Index |