Electronics > Projects, Designs, and Technical Stuff
MAX232 BAKCKPOWERING RAIL
(1/1)
jismal:
Hello Guys

Does someone face issue of standard MAX232 driver back powering the power rail?
Anyway, my IC was SP232. The issue comes as follows.
#1 When I connect my RS232 ports to the device without powering the device on, The SP232 will not back power.
#2 But when I remove the power of the device with RS232 still connected, the SP232 is back powering.
#3 When I put a 100 ohm load on the back powering rail this back powering is turned off.
# My RX voltage was around -5.85 Voltage and back powering rail was around 2.45 volt enough to power the led.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod