| Electronics > Projects, Designs, and Technical Stuff |
| MB85RC64TA FRAM Trouble Writing/Reading [SOLVED] |
| << < (3/3) |
| SiliconWizard:
--- Quote from: ANTALIFE on September 29, 2019, 01:42:00 pm ---When I do get out the logic analyser for the MB85RC64TA, the weird thing is that all commands are acknowledged and match up to what the datasheet says. --- End quote --- If your commands get acknowledged, then it basically means the chip understands them. If the data it puts out is invalid or all zeros whatever command you send, that's quite fishy. A totally borked IC or a problem with communication would probably yield commands to be NACK'ed. To further make sure there is no signal integrity problem, take a loot at the I2C signals with a scope. Logic analyzers are handy, but they don't show anything much if there's any signal integrity issue. |
| SiliconWizard:
--- Quote from: wraper on September 28, 2019, 07:55:17 pm ---Relabeled IC's don't look polished. --- End quote --- Well, it may not be a counterfeit, but it could very well be. The worst counterfeits are not even polished or sanded. They are merely OVERSPRAYED before being marked again, and frankly, this exactly looks like a nasty overspraying job here. Looking at the chips from their sides would confirm this - you should relatively clearly see a "line" between the top "resprayed" layer and the rest of the package. |
| wraper:
--- Quote from: SiliconWizard on September 29, 2019, 07:56:05 pm --- --- Quote from: wraper on September 28, 2019, 07:55:17 pm ---Relabeled IC's don't look polished. --- End quote --- Well, it may not be a counterfeit, but it could very well be. The worst counterfeits are not even polished or sanded. They are merely OVERSPRAYED before being marked again, and frankly, this exactly looks like a nasty overspraying job here. Looking at the chips from their sides would confirm this - you should relatively clearly see a "line" between the top "resprayed" layer and the rest of the package. --- End quote --- FYI blacktopping does not look glossy as much as I've seen. |
| wraper:
Here are 2 another Fujitsu FRAM which are glossy on top and matte on bottom. https://lcsc.com/product-detail/FRAM_FUJITSU_MB85RS2MTAPNF-G-BDERE1_MB85RS2MTAPNF-G-BDERE1_C189908.html https://lcsc.com/product-detail/FRAM_FUJITSU_MB85RS128TYPNF-GS-BCERE1_MB85RS128TYPNF-GS-BCERE1_C189906.html |
| Navigation |
| Message Index |
| Previous page |