Electronics > Projects, Designs, and Technical Stuff
Measuring Current on DC Power Supply
<< < (4/4)
xavier60:
Many single op-amp packages have the offset nulling pins. The TL081 just happened to be the first one I found that has an input common mode input range including the +rail.   An op-amp with better offset specs can be chosen.
Providing the -5V control rail is sounding like a good idea. It will allow the MOSFET to be properly controlled by compensated CV and CC op-amps via OR-ing diodes with a constant current source for Gate pull-up.
xavier60:
With the  -5V control rail, IC2b can fully control the Non-inverting input of IC2d directly via a diode, eliminating Q2.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod