Electronics > Projects, Designs, and Technical Stuff

Mystery tin resistor box

<< < (5/8) > >>

enut11:

--- Quote from: Gyro on May 25, 2020, 09:35:15 pm ---It looks as if that box has already been opened - there is no continuous solder fillet (unless it is just the photo angle), maybe just tack-soldered in a few places.

--- End quote ---

Nope, there is continuous solder around the lid with no evidence of tampering

bob91343:
I would try my hot air desoldering station on small areas.  I have opened boxes like this by heating with a big iron and forcing a screwdriver into the solder.  Once you get purchase you can try to bend it, as the solder is softer than the can.

exe:
Drill a hole and use a borescope  :horse:  :popcorn:

enut11:
That would be too easy. Where is the challenge?

bdunham7:
Can you measure 11-13 and 7-10? And maybe 2-8 and 2-9?

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod