Electronics > Projects, Designs, and Technical Stuff

Need help identifying this connector (pics included)

(1/2) > >>

andyg:
Hello,

Does anyone know what type of connector this is? I've tried looking at the usual places I buy components without any luck, although I'm not really sure what this is categorised as. It's a through hole connector which  takes a approx 0.7mm square crimp male pin, pushed in horizontally to the PCB. Thanks.

bob91343:
It appears to be a custom made device made from eyelets put into some insulation stuff.  You can make one yourself.

edba:
Looks like a horizantal side entry female header, where they have just cut a example a 10 row connector into individual connectors. Pls see link below:

https://www.e-tec.asia/products/board-to-board-wire-to-board-connectors/female-header.html

andyg:

--- Quote from: edba on April 20, 2020, 07:46:07 pm ---Looks like a horizantal side entry female header, where they have just cut a example a 10 row connector into individual connectors. Pls see link below:

https://www.e-tec.asia/products/board-to-board-wire-to-board-connectors/female-header.html

--- End quote ---

Thanks @edba - that looks about right!

WattsThat:
Sure looks like the business end of a Pace SX-70 TH desoldering tool. The board looks pretty toasty, hope you can repair without the board crumbling. If not, the entire assembly can be had (for a price).

http://www.techni-tool.com/612PA098

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod