Electronics > Projects, Designs, and Technical Stuff

Need help with amplifier

<< < (3/3)

Audioguru again:
I agree that the datasheet does not show BTL driving a 4 ohms speaker because with the much higher power then the IC will melt.
It can drive a 4 ohm speaker is the supply voltage is reduced enough (try 14V) for the maximum low distortion output to be a little less than 25W.

laejf:

--- Quote from: Audioguru again on October 26, 2019, 04:49:23 pm ---I agree that the datasheet does not show BTL driving a 4 ohms speaker because with the much higher power then the IC will melt.
It can drive a 4 ohm speaker is the supply voltage is reduced enough (try 14V) for the maximum low distortion output to be a little less than 25W.

--- End quote ---

I have not thought about that, thanks for clarifying!

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod