Electronics > Projects, Designs, and Technical Stuff
Need help with programming I2C ADC using arduino
(1/2) > >>
OM222O:
Hello
I made a board using an atmega328p-au (arduino nano) , an ADS1219 and a voltage reference.
I'm not very good with programming, especially for I2C communication. Can somebody help me get the circuit to work?
archnemesis:
Try Google.

I hope that answer was as frustrating for you as reading your question was for me.
OM222O:
I tried googling , searching github and even the arduino froum  :-DD
archnemesis:
But you offer no indication of anything you've tried, what you're even having issues with. Did you write any code?
OM222O:
I found some codes which are for the ADS1115 (a very similar product, 16 bit I2C ADC) and tried modifying it to work with the 24 bit ADS1219 but I had no luch tbh. My main issue is using the register maps given in the data sheet and writing / reading data to / from them.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod