Electronics > Projects, Designs, and Technical Stuff
New uRuler
<< < (31/31)
boshepard69:
Hey Dave!  Love your videos. I have learned so much watching them.  I used to be a Broadcast TV designer, but now I just work on electronics as a hobby. How do I go about purchasing one of these rulers? 
EEVblog:

--- Quote from: boshepard69 on January 27, 2020, 09:31:02 am ---Hey Dave!  Love your videos. I have learned so much watching them.  I used to be a Broadcast TV designer, but now I just work on electronics as a hobby. How do I go about purchasing one of these rulers?

--- End quote ---

Good question...
I should get off my arse this year.
The question is who to use to manufacture them this time around?
boshepard69:
Keep up the great work!  Everyone appreciates what you do.
cj555:
Ooh yay! I'm setting up my little lab finally, so I'd be glad to pick up a ruler or three.
scopeman:

--- Quote from: EEVblog on January 27, 2020, 10:23:01 am ---
--- Quote from: boshepard69 on January 27, 2020, 09:31:02 am ---Hey Dave!  Love your videos. I have learned so much watching them.  I used to be a Broadcast TV designer, but now I just work on electronics as a hobby. How do I go about purchasing one of these rulers?

--- End quote ---

Good question...
I should get off my arse this year.
The question is who to use to manufacture them this time around?

--- End quote ---

Dave,
How about making it longer than 12 inches, maybe 15 or 18. Also add the 0.3" spacing for through hole use.

Regards,
Sam
W3OHM
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod