Electronics > Projects, Designs, and Technical Stuff

New uRuler

<< < (31/31)

boshepard69:
Hey Dave!  Love your videos. I have learned so much watching them.  I used to be a Broadcast TV designer, but now I just work on electronics as a hobby. How do I go about purchasing one of these rulers? 

EEVblog:

--- Quote from: boshepard69 on January 27, 2020, 09:31:02 am ---Hey Dave!  Love your videos. I have learned so much watching them.  I used to be a Broadcast TV designer, but now I just work on electronics as a hobby. How do I go about purchasing one of these rulers?

--- End quote ---

Good question...
I should get off my arse this year.
The question is who to use to manufacture them this time around?

boshepard69:
Keep up the great work!  Everyone appreciates what you do.

cj555:
Ooh yay! I'm setting up my little lab finally, so I'd be glad to pick up a ruler or three.

scopeman:

--- Quote from: EEVblog on January 27, 2020, 10:23:01 am ---
--- Quote from: boshepard69 on January 27, 2020, 09:31:02 am ---Hey Dave!  Love your videos. I have learned so much watching them.  I used to be a Broadcast TV designer, but now I just work on electronics as a hobby. How do I go about purchasing one of these rulers?

--- End quote ---

Good question...
I should get off my arse this year.
The question is who to use to manufacture them this time around?

--- End quote ---

Dave,
How about making it longer than 12 inches, maybe 15 or 18. Also add the 0.3" spacing for through hole use.

Regards,
Sam
W3OHM

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod