Electronics > Projects, Designs, and Technical Stuff
Non-plated hole on an SMD Pad in Eagle Autodesk?
(1/2) > >>
gmanda:
Hi,

I'm trying to make a footprint on Eagle for the following component (https://www.digikey.com/product-detail/en/LAMA2-14-QY/298-10109-ND/317639/?itemSeq=298643028) and I'm thinking of doing an SMD pad with a through hole in it. However, I'm not sure how to do a through hole in an SMD pad. Anyone have any suggestions on how I can achieve this?

Thanks.
wraper:
If there is a hole, it's not SMD pad. I don't use Eagle but in general I would make rectangular/custom shape TH pad or make opening in solder mask around regular TH pad.
wraper:
5 seconds of googling.

gmanda:
Thanks man... I think I might have been googling it bad.. thanks again! appreciate your help
wraper:
I misread your question a bit in regards of non-plated. But first of all there is no reason making non plated hole in pad for this. Secondly, if you will will make a hole in pad without any gap between hole and copper, PCB fab will make plated hole anyway.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod