Electronics > Projects, Designs, and Technical Stuff
OLED voltage levels...
<< < (5/5)
alank2:

--- Quote from: Fungus on October 03, 2015, 04:50:40 pm ---But when I wrote the original post the OP was saying: "I made it step from 0x00, to 0x8F, to 0xFF, but I only see two brightness steps and only see two distinct steps when monitoring current."

--- End quote ---

I must have done something wrong for that, not sure why.  It is working now and definitely has the 256 steps.

I guess the question is, does using the contrast setting OR adjust the iref resistor both accomplish roughly the same thing?
amyk:

--- Quote from: alank2 on October 03, 2015, 05:44:58 pm ---I guess the question is, does using the contrast setting OR adjust the iref resistor both accomplish roughly the same thing?

--- End quote ---
Iref is the "master contrast", it sets the maximum current. The contrast setting divides that into 256 steps.
reetpetite:
Hello alank2 and all other contributors,
I bought the same displays and I am struggling to connect them properly. What do you mean by “uc” on pins 9, 10, and 11?
Best regards
alank2:
By uc I mean microcontroller.  Those pins need to go to a general purpose I/O to reset it and the other two to the i2c interface on the microcontroller.  Good luck!
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod