Electronics > Projects, Designs, and Technical Stuff

on-the-fly inductor resonance frequency finding

<< < (9/9)

PCB.Wiz:

--- Quote from: Rx7man on September 27, 2023, 08:14:58 am ---OK, that makes sense.

I'm not too concerned about the slew rate pulling the frequency away from the theoretical ideal, as long as it's kinda predictable/steady

--- End quote ---

You need to check with a scope that the lowest inductance end (11.5mH?) still at least manages a full swing, even if it is more a clipped triangle, than slow square wave.

Rx7man:
With my upcoming move I'm going to have to put this on the back burner for a bit, and I'll work on just learning more in the meantime!
Thanks for all the help, making sure I know where i am on the dunning-kruger curve!  :phew:

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod