Electronics > Projects, Designs, and Technical Stuff
Part Search 7 Segment Display
james_s:
I'd be shocked if tolerances are so tight that 1/100th of an inch matters. Either way they're so cheap you could buy a few and try them.
DaJMasta:
Size would only matter if you're matching other displays, the size they're advertising is the size of the digit, not the size of the package or the PCB pins - there are usually technical drawings for this, but I think most of these sized displays will be standard DIP pin spacing and arrangement. Though there can be some variation in pinout and the common cathode vs. common anode to make sure match your requirements.
ChrisGreece52:
Oh ok since i am not matching them with other displays ill go for them.
Navigation
[0] Message Index
[*] Previous page
Go to full version