Electronics > Projects, Designs, and Technical Stuff
potting contacts
<< < (4/4)
Simon:

--- Quote from: Hero999 on December 10, 2018, 10:48:44 am ---
--- Quote from: Simon on December 09, 2018, 09:32:00 pm ---I was thinking a PCIe connector as they are cheap and the mating half is free. I don't think I'd pot one. I'd have to come up with something else. probably redesign the boards with smaller contacts of the same type both sides and via's that way the connection goes straight through.

--- End quote ---
How about cutting a slot in one board and soldering the edge of the other board to it?

--- End quote ---

Yes I think that that will be best for a potted version
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod