| Electronics > Projects, Designs, and Technical Stuff |
| Power Amplifier AB class |
| << < (5/6) > >> |
| strawberry:
some new great design files |
| TurboTom:
You're sure Q16 and Q17 are the correct polarity? ;) |
| strawberry:
best design for sure ;) |
| Mechatrommer:
--- Quote from: strawberry on June 20, 2019, 05:22:26 pm ---best design for sure ;) --- End quote --- 100W + no heat sink = burnt |
| mariush:
imho any design that's mostly through hole and then gives up and uses surface mount on the bottom gets disqualified. In the example above, designer could have used a couple tiny circuit boards to place the surface mounted stuff om them and then use a couple headers to plug them into the main board (like SIP packages, RAM sticks ) ... or just use through hole parts ... so the whole design could have been single sided ... there's plenty of room on the board to do something like that. Not to mention the lack of heatsink mounting options (Screw holes, silkscreen etc), and the weird placement of those 4 resistors at the top right by the holes |
| Navigation |
| Message Index |
| Next page |
| Previous page |