Electronics > Projects, Designs, and Technical Stuff

Power supply connection issue

<< < (3/3)

MarkF:
Maybe two of these mounted to the top of the power supply with short jumpers to the power supply terminals:

    https://jaydeeautocables.com.au/products/neutral-bar-brass
   

OR

    https://shop.pkys.com/BEP-Pro-Installer-Z-Bus-Bar--10-Way--200A_p_5786.html
   

MarkF:
Searching for marine power distribution bus bars will give you a lot of options.

Or you could drill and tap two copper bars to achieve the same thing.

drummerdimitri:
I like the bus bar idea and have already crimped and connected the 8 wires to the power supply.

Will attempt to solder each of the 4 pairs to a piece of copper salvaged from household power board bus bars , drill a hole in it and screw on the 8 AWG lug and heat-shrink the whole  thing. should be fine I guess as I doubt I will ever find a butt connector capable of accommodating the cables where I live.

drummerdimitri:
Jobs done thanks guys!

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod