Electronics > Projects, Designs, and Technical Stuff
power supply enclosure
<< < (4/7) > >>
Tek Tech:
The LRS 150 already has a semi-decent enclosure (depending where you want to use it).
You could cut out a comb-shaped cover out of polycarbonate for all the exposed terminals and attach it with a couple of nylon screws into unused terminals, or cable ties fastened around the cables.
LaserTazerPhaser:

--- Quote from: Tek Tech on April 26, 2019, 11:21:44 pm ---The LRS 150 already has a semi-decent enclosure (depending where you want to use it).
You could cut out a comb-shaped cover out of polycarbonate for all the exposed terminals and attach it with a couple of nylon screws into unused terminals, or cable ties fastened around the cables.

--- End quote ---
The manufacturer seems fine https://www2.vde.com/en/institute/onlineservice/vde-approved-products/pages/ProductDetails.aspx?cid=fe75a5133ab948a18c2d9355e76f04f5

What did you mean by comb-shaped cover?
queennikki1972:
i have in the past 3D printed faces or cover plates with banana jacks, switch etc. I have seen many covers that were printed for those types of power supplies on Thingiverse.com I think.

https://www.thingiverse.com/search?q=meanwell&dwh=365cc3a635221bf

I have a printer and located in Texas if anyone needs help maybe I can help.

Nikki
Tek Tech:

--- Quote from: LaserTazerPhaser on April 26, 2019, 11:57:02 pm ---What did you mean by comb-shaped cover?

--- End quote ---

Something shaped as the one below:
beanflying:

--- Quote from: Tek Tech on April 27, 2019, 04:41:55 am ---
--- Quote from: LaserTazerPhaser on April 26, 2019, 11:57:02 pm ---What did you mean by comb-shaped cover?

--- End quote ---

Something shaped as the one below:

--- End quote ---

I have a few similar listed here https://www.eevblog.com/forum/testgear/replacement-knobs-feet-and-fittings-for-test-equipment/msg2255109/#msg2255109

In particular this is one to suit a HP Supply https://www.thingiverse.com/thing:2476186

Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod