Electronics > Projects, Designs, and Technical Stuff
programming ATMEGA328p using PICKIT3
(1/2) > >>
hussamaldean:
Dear all,
I am currently learning MPLAB X to program both PIC and ATMEGA. anyway is there any way to upload the code to ATMEGA328p since I searched the web to figure out but I came up empty handed
regards
Howardlong:

--- Quote from: hussamaldean on October 28, 2019, 03:11:40 pm ---Dear all,
I am currently learning MPLAB X to program both PIC and ATMEGA. anyway is there any way to upload the code to ATMEGA328p since I searched the web to figure out but I came up empty handed
regards

--- End quote ---

Pretty sure that Pickit3 is for PICs only, it was developed well before Atmel became part of Microchip.

I did have some luck recently with a PICkit4 programming an ATTiny from MPLAB X, but it was reasonably hard work getting everything to work. In the end I went back to using Atmel Studio and an Atmel ICE, there are fewer unknowns that way. If you have to fight too hard with your debugging tools, IME you're probably better off taking a different approach.
hussamaldean:

--- Quote from: Howardlong on October 28, 2019, 04:15:43 pm ---
--- Quote from: hussamaldean on October 28, 2019, 03:11:40 pm ---Dear all,
I am currently learning MPLAB X to program both PIC and ATMEGA. anyway is there any way to upload the code to ATMEGA328p since I searched the web to figure out but I came up empty handed
regards

--- End quote ---

Pretty sure that Pickit3 is for PICs only, it was developed well before Atmel became part of Microchip.

I did have some luck recently with a PICkit4 programming an ATTiny from MPLAB X, but it was reasonably hard work getting everything to work. In the end I went back to using Atmel Studio and an Atmel ICE, there are fewer unknowns that way. If you have to fight too hard with your debugging tools, IME you're probably better off taking a different approach.

--- End quote ---
seems I will use arduino as ICP with gui-avrdude 
iMo:
This is a must for an atmel user :)

USBASP Programmer

Adapter (optional)
hussamaldean:

--- Quote from: imo on October 28, 2019, 04:29:07 pm ---This is a must for an atmel user :)

USBASP Programmer

Adapter (optional)

--- End quote ---
I have this but it doesn't work with MPLAB X  :-\ :-\ :-\ :-\
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod