Electronics > Projects, Designs, and Technical Stuff
PSA: Do not use the CP2102N USB to serial converter in your designs (for linux)
<< < (3/5) > >>
oPossum:
CH340B, CH340C and CH340E do not require a crystal.

CH340E is MSOP10 package.
stj:
adding my experience, +1 for WCH chips 340/341 series.
never had an issue with them - they seem o.k. on windowz too, but i didnt test that much - just on my eeprom programmer.

jeremy:
Thanks for the pointers. I do normally use the CH340, but for the ESP32 you need both RTS and DTR. This means that you need to use the SOIC-16 version of the CH340, which is pretty big compared to a QFN, which is why I was trying to use the CP2102N. I think I'll just try to use the CP2102 instead for now.
bson:
Never FTDI.  :--  I'll never use any of their products.
radar_macgyver:
So just in case anyone else stumbled on this, the original thread on Silabs' forum indicates that this was caused by a firmware bug that was fixed in the CP2102N-A02 version of the chip. I guess the underlying micro used can't be reflashed?
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod