Electronics > Projects, Designs, and Technical Stuff
PT1000 over distance, possible safety features
(1/1)
Radiosonde:
Hello
For my home weather station I plan to utilise PT1000 RTDs , I would design a PCB with a SMD RTD on it which can slide in a already existing Thies sensor radiation shield, it would be connected via 4 wires over 20m of shielded cable.
For readout I plan to use an MAX31865, the datasheet insists in a 10nF capacitor mounted between the two sensing lines.
Should I place this capacitor on the PCB or on the readout board?
Are there any other suggestions regarding to necessary components directly at the RTD or can I leave it just like that?

Regards
Siwastaja:
Next to the MAX31865, so it filters differential noise coupling to the wires, and also provides ESD protection.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod