Electronics > Projects, Designs, and Technical Stuff
PWM and overvoltage fault detection
(1/1)
gaminn:
Hi,
I created this schematic and I'm not sure if it does what I want. It is 74AHC123A dual monostable multivibrator. There are two inputs:

1) LED_OVERVOLTAGE: high when there is overvoltage, low when the voltage is normal
2) LED_PWM: 10 kHz PWM (that controls LED driver)

There is one output, LED_FAULT. I want LED_FAULT go high when there is either LED_OVERVOLTAGE (immediately, without any delay, thus it is connected to reset input of the multivibrator) or when LED_PWM is stuck for several periods (this is set by R7/C5) in low or in high state.

Will it work or can you help me modify it?
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod