Electronics > Projects, Designs, and Technical Stuff

Reading AMI 18CV8PC-25


How read Ami 18CV8-PC chip with modern programer ( usb) ? I find only comercial stuff, for lot of money. Any cheap solution - arduino maybe (dupal don't support peel chips) ? or DIY - any help welcome !!

No way. This is a beast from deep past that should be programmed with special piece of hardware. Manufacturer didn't provide programming specification for it to public.
And programming of it requre high voltage (in range 12-24V) and precise timing. So it is not easy to build DIY programmer for it even docs will be found.

You can try to restore logic of it by probing input/output (this PLD is a quite small one), but it could be problematic, because it has triggers inside.


[0] Message Index

There was an error while thanking
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod