Electronics > Projects, Designs, and Technical Stuff

Recommendation for pluggable connector

(1/1)

mickeysceme:
Hi guys,

My name is Mike, I am currently working as a Mechanical Design Engineer in the lighting industry. The project I am working on involves electrical part in it, and selection of drivers and connectors amongst other tasks.

I am looking for a 2 pole/circuit connector that will look like this one wago 890

I am looking for something more compact with push in wire capabilities, ideally panel mount on one side and plug on the other. If possible, with a latch for locking.

I also checked for AVX, BINDER, PHOENIX, TE and MOLEX vendors. All connectors require assembly of pins and wires to complete the harness assembly, I am looking for push in or some other mechanical quick assembly that does not require additional processes.

Any help is very much appreciated.

Best regards,

Mike

TimNJ:
So you want to push the wire into a male plug, and then plug that into a female header on the product?

Do you need to use a plug-able connector? How about plugging bare wire directly into the product with spring-loaded contacts? Not allowed?

ajb:
What are your current/voltage requirements?

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod