Electronics > Projects, Designs, and Technical Stuff

Reed switch coil design

(1/1)

edba:
Hi

I have a reed switch (STANDEXMEDER MK23-85-C-2) and I want to wind a coil onto the glass body to be able to operate as a reed relay. The reed switch glass body winding area is 15mm appx x 2.75mm dia winding area. The contacts are specified to close between 15-20AT. I know I had a book years ago explaining how you could wind a coil on the body to operate it. Ideally I would want to operate the reed relay with a 20mA current at 5V. Does anyone know about the calculations involved in working out the number of turns required?

Edba

langwadt:
something along these lines 20AT/20mA = 1000 turns, adjust wire size until you get 5V/20mA  = 250 Ohm

edba:
Hi

Thamks for your reply. I would like to do a bit more reading about this, do you know of a good tutorial on the web? Also do you know of the formula for calculating the length of wire vs no. of turns for thickness of wire. I have done some coil design but not for about 25 years!

Edba

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod