| Electronics > Projects, Designs, and Technical Stuff |
| Reflowing my first BGA: Tips needed |
| (1/1) |
| lawrence11:
So I have my controleo3 all ready, its been "learned" and received high grade, the profile program has been tested. I am reflowing on 1 chip ATM due to them being the only leadfree BGA of the gang, a 216 bga .8mm with no balls in the middle. Should I risk aligning manually? Or should I contatc somebody with an xray to help? Is manually best I can good enough? Should I put some flux on the pcb copper pads of the bga? This my flux https://www.amazon.com/Solder-Welding-Electronic-Soldering-Lead-free/dp/B076M49M63/ref=sr_1_47?keywords=solder+flux&qid=1568731253&s=gateway&sr=8-47 |
| Navigation |
| Message Index |