EEVblog Electronics Community Forum
A Free & Open Forum For Electronics Enthusiasts & Professionals
Welcome,
Guest
. Please
login
or
register
.
Did you miss your
activation email
?
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
This topic
This board
Entire forum
Google
Bing
Home
Help
Search
About us
Links
Login
Register
EEVblog Electronics Community Forum
»
Electronics
»
Projects, Designs, and Technical Stuff
»
Reflowing my first BGA: Tips needed
« previous
next »
Print
Search
Pages: [
1
]
Go Down
Author
Topic: Reflowing my first BGA: Tips needed (Read 459 times)
0 Members and 1 Guest are viewing this topic.
lawrence11
Frequent Contributor
!
Posts: 322
Country:
Reflowing my first BGA: Tips needed
«
on:
September 17, 2019, 02:42:38 pm »
So I have my controleo3 all ready, its been "learned" and received high grade, the profile program has been tested.
I am reflowing on 1 chip ATM due to them being the only leadfree BGA of the gang, a 216 bga .8mm with no balls in the middle.
Should I risk aligning manually? Or should I contatc somebody with an xray to help? Is manually best I can good enough?
Should I put some flux on the pcb copper pads of the bga?
This my flux
https://www.amazon.com/Solder-Welding-Electronic-Soldering-Lead-free/dp/B076M49M63/ref=sr_1_47?keywords=solder+flux&qid=1568731253&s=gateway&sr=8-47
Logged
Print
Search
Pages: [
1
]
Go Up
« previous
next »
Share me
Smf
EEVblog Electronics Community Forum
»
Electronics
»
Projects, Designs, and Technical Stuff
»
Reflowing my first BGA: Tips needed
There was an error while thanking
Thanking...
EEVblog Main Site
EEVblog on Youtube
EEVblog on Twitter
EEVblog on Facebook
EEVblog on Odysee