Electronics > Projects, Designs, and Technical Stuff
Reflowing my first BGA: Tips needed
(1/1)
lawrence11:
So I have my controleo3 all ready, its been "learned" and received high grade, the profile program has been tested.
I am reflowing on 1 chip ATM due to them being the only leadfree BGA of the gang, a 216 bga .8mm with no balls in the middle.
Should I risk aligning manually? Or should I contatc somebody with an xray to help? Is manually best I can good enough?
Should I put some flux on the pcb copper pads of the bga?
This my flux https://www.amazon.com/Solder-Welding-Electronic-Soldering-Lead-free/dp/B076M49M63/ref=sr_1_47?keywords=solder+flux&qid=1568731253&s=gateway&sr=8-47
Navigation
[0] Message Index
Go to full version